Impaction E12S-787 kit, Fly-bar

In order to convert a conventional impaction E12S-720 a more high-powered MOTOR efficiently kinetic energy,

Supports Long of the order to lengthen the main rotor to the maximum on the rules (787mm length).

As a result, the time of overflight to facilitate performance with high-speed and constant velocity sense, and also at the time of autorotation

Buoyancy of the margin can experience. Of course, if you select a 700mm blade by preference, overflight also possible with brisk and off.

Main specifications change from E12S-720 will be the contents of the following.

Change to double bearing seesaw

Change to the head damper 50 degrees → 60 degrees

Change to the stabilizer bar 500mm → 530mm

Change to grip thickness 12 → 14mm of main rotor (color for 12mm will be OP)

Lightweight and adopted HG tail boom holder machined aluminum of high rigidity.

By HP tail grip 3 blade (0 °), and is enhanced retention of the tail.

For carbon tail boom 787mm

For carbon linkage rod 787mm

Carbon tail support pipe 680mm

Tail drive belt (2025) for 787mm

Tail rotor (95 ~ 110mm) 3Blade / Recommended (B057FT · tail rotor 105 (3 sheets))

Main Rotor (grip thickness 14mm) (700 ~ 787mm)

Stabilizer blade / recommendation (FUNTECH 60,90 paddle) ※ FB only

Motor / recommended (Quest QP0028 / BLS4730-520 motor and equal to or more than)

Amplifier (ESC) / LiPo12 cell / 160A or more (700 ~ 720mm more than 120A)

Battery (sold separately) 6s-5800mAh × 2

Propo (sold separately) 6ch more for each company helicopter

Servo × 4

Gyro × 1

TECHNICAL DATA

Full length 1,495mm

Full width 200mm

Total height 435mm

Gear Ratio 10.53: 1: 5.06

Gross weight About 5,400g

Main rotor diameter 1,726mm (when 760mm rotor use)

Tail rotor diameter 290mm (105mm at the tail rotor use)

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating Bad Good

Enter the code in the box below

Impaction E12S-787 kit

Qty